1、概述
该型电加热器外形美观，安装、使用、维护方便，适用于船舶舱室内冬季加热、取暖，改善工作、休息环境。
2、型号说明

3、安装
3.1 用适当长度4个M8螺栓，经四个安装孔，将加热器固定在舱壁安装座上。
3.2 拆卸电器盒盖，将电缆线经接线填料函固定在接线端子上，将接线盒盖好。
注意：本加热器应低于1m以下安装，并与地面留有200mm以上空间。

4、使用
4.1 确认接线牢靠无误后，接通电源。
4.2 旋转侧面板上温控器旋钮，调定所需室温。
4.3 将旋钮开关旋转至“开”位置，电加热器开始工作。
4.4 当室温达到设定温度时，加热器自动停止加热；室温下降后，加热器自动恢复加热；若不需要对室内加热，只需将旋钮开关向左旋转即可。
4.5 加热时，不得触摸加热器外壳，以免被高温烫伤。
4.6 不得将潮湿物及棉毛织品等易燃物放置于加热器上。
4.7 注意勿使大量的水溅至加热器上。

5、维护保养
根据环境空气的清洁度，定期对加热器进行维护保养，在停止加热的情况下，拆卸前面板，用毛刷清除加热管表面积灰。
6、故障及排除

7、附图
7.1 电加热器外形图
7.2 电气原理图（接线图）


1. Brief description
This type of electric heater has beautiful outline, and the installation、operation and maintenance is very easily, It can be used for warming in the cabins as to improve the working and resting environment in winter.
2. Specification

3. Installation
3.1 Fixing the heater to the installation base on the cabin wall using four M8 bolts of suitable length through the four installation holes in the installation panel.
3.2 Removing the front cover board of electric set which electrical connector installed , and mounting after wiring according to the electrical principle drawing.
Note: the installation height should lower than 1m,and the distance to ground must greater than 200mm.
4. Operation
4.1 After checking the wire, then turn on the power supply.
4.2 Turn the temperature-control knob on the side panel to the temperature needed.
4.3 Turn on the switch at “ON” station, the heater will be working .
4.4 When the temperature is lower than set point, the heater will heat automatically, If the heating is not needed, you only need rotate the switch to the left side.
4.5 when heater is be working , touching the heater is forbidden to avoid scalding.
4.6 Putting the moist object and flammability such as linsey-woolsey on the heater is forbidden.
4.7 Does not let a great lot water spatter to the heater.
5. Maintenance
Maintaining the heater periodically according to the cleanness of air. When the heater is not in work, remove the front cover, and clean the heating pipes with brush.
6. Troubleshooting

7. Drawings
7.1 Drawing of outline and installation size
7.2 Electric principle drawing